• HOME
  • HF
  • VHF-UHF
  • AMPLIFIERS
  • STaR Transceivers

  • Various Circuits
  • EME Moonbounce
  • 70cm EME
  • 23cm EME
  • 13cm EME
  • 9cm EME
  • 6cm EME
  • 3cm EME
  • 24GHz EME

VK3NX





Australian Amateur Radio STation



10 GHz EME



Equipment on 3cm


- A homebrew transveter based on the DEMI board is used for the 10 GHz transverter. The transverter is used as my "terrestrial" transverter and incorporates a homebrew 3W amp and the DEMI 8 W amplifier. There is provision for a low level (+10dBm ) output on the rear panel which when selected disengages the internal PA's. This low level RF is used to drive the EME TWTA.

- The TWTA is an NEC which produces 100 W RF on 10368MHz and with the associated piece of LMR600 I am getting about 75-80W at the feed of the 3.7m dish.

-The LO is a homebrew design utilising the circuit in the "ARRL Microwave handbook" as the basis and is locked to a GPS derived 10 MHz signal with a "VE1ALQ" PLL board.

-LNA is a DB6NT preamp. Measured NF is 0.7dB and the gain is 26dB

- A W/G switch is used with a simple feed horn utilising a single "VE4MA" style choke flange. 1 W/G to SMA transition exists on the input to the preamp.

- IF frequency is 144 MHz.



NEW FEED WITH SUPER VE4MA CHOKE FLANGE FITTED JAN 2015

Sun Noise = 14.8 (SFU = 148)
Moon Noise = 1.65dB
CS / Gnd = 4.2



Using a Large bolt of 22mm diam, (0.77wL), shaped to a point over ~ 2wL, the WR75 Waveguide piece was heated and flared out to circular. A 3 screw tuner (utilising only 2 screws) was used to achieve a 25dB RL. A Super VE4MA choke flange was fitted and adjusted for best illumination. This feed produced about 0.25dB more moon noise compared with the original feed which utilised an "original" dimensioned VE4MA choke flange.



Audio Clips or 3cm EME signals


RW1AW
HB9Q - SSB
OK1KIR
VK3NX at JA1WQF
VK3NX - Echo_1
VK3NX - Echo_2

3cm EME Log book


Log Book

VK3NX